Learning objectives
-
Draw the field patterns around a straight wire and a solenoid, including arrows to show direction.
-
Explain how current and distance affect the field around a wire, and how coil turns and an iron core affect a solenoid.
-
Use Fleming’s left-hand rule to predict force direction and apply F = BIℓ to a conductor at right angles to a magnetic field.
-
Explain how forces turn a motor coil and how a moving voice coil produces pressure variations in air.
Using the studio
-
Straight wire and field plotting. Close the switch with the compass 2 cm from the wire. Increase the current from 2 A to 4 A and watch the wire’s field reading rise from 20 µT to 40 µT. Ask, “If we keep the current at 4 A but move the compass to 4 cm, what will the meter read?” Test the prediction, then open Plot a field. Record all eight compass directions and ask students to sketch the curve before pressing Play to join the marks.
-
Solenoid and relay. Vary the current, turn count and iron core one at a time. Ask students to identify where the field lines are parallel and evenly spaced, then compare the external pattern with Bar magnet. For separate Physics, step through Relay. Ask students to trace the lamp circuit and explain how energising the control coil closes its contacts.
-
Force lab — Higher Tier. In Measure force, use 0.40 T and an active wire length of 0.10 m. Record the forces at 1 A, 2 A and 4 A. The readings are 0.04 N, 0.08 N and 0.16 N. Open Graph and ask students to state the relationship in words before selecting Explain results. In Find the direction, predict the effect of reversing the current, swapping the poles, and then doing both.
-
Electric motor — Higher Tier. Follow side A in End-on view from 0° to 90°. At 90°, switch to Commutator so students can see the brushes at the insulating gaps. Ask, “When contact resumes, which way will the force on A act?” Step to 135° to check. The force on A now acts downwards. Side A has also crossed to the other side of the axle, so the forces keep the coil turning in the same direction.
-
Loudspeakers and headphones — separate Physics, Higher Tier. Play the loudspeaker animation and follow the marked air particle. Ask, “What reaches the listener while this particle moves back and forth?” Switch to Headphones at the same signal settings to see how a smaller diaphragm uses the same mechanism close to the ear. Vary frequency to explore pitch, then vary amplitude at a fixed frequency to explore loudness.
Teaching tips and common misconceptions
-
Choose the hand rule to match the question. The right-hand grip rule gives the field direction around a wire. Fleming’s left-hand rule gives the force direction on a current-carrying conductor in an external field. A dot means towards the viewer and a cross means away.
-
Read field strength from the meter. The maps keep a fixed scale as intermediate lines appear. With Earth’s field switched on, the compass follows the combined field, while the meter reports the wire’s contribution.
-
Identify the active length before calculating. In F = BIℓ, ℓ is the length of wire inside the field, measured in metres. Worked demonstrates the centimetre conversion. Guided keeps earlier values visible in Established so far while students find the current.
Practical safety
For a real wire or solenoid demonstration, follow the school’s risk assessment, use an appropriate low-voltage supply and switch off between observations because the wire can heat up. [IOPSpark]https://spark.iop.org/magnetic−field−due−electric−current−wire?utmsource=chatgpt.com
Display and independent learning
For whole-class teaching, select Projector and use Step to hold the motor or relay at the point where students can predict what happens next. For independent work, ask for one labelled field sketch, one conclusion supported by force readings and one explanation of a device. Calculations and Concept check provide follow-up practice with feedback.